Wireless Multi-Function Access Point

Firmware Upgrade : the device can be upgraded to the latest firmware through the WEB based GUI.

1.4System Requirements

Before installing the device, your PC should meet the following:

ƒIntel® Pentium®III 600Mhz or compatible processor with TCP/IP stack

ƒIinternet Explorer V6.0 on Netscape V6.0

ƒCDRom

1.5 Setup

The setup of the Wireless Access Point can be performed using the following steps:

Visually inspect the Ethernet RJ45 port connector and make sure that it is fully plugged in to the system’s Ethernet switch/hub port.

Fix the direction of the antennas. Try to place the AP in a position that can best cover your wireless network. Normally, the higher you place the antenna, the better the performance will be. The antenna’s position enhances the receiving sensitivity.

Visually inspect if the Power Adapter was fully plugged to the device power jack.

A02-AP1-W54

Pag. 3