Wireless Multi-Function Access Point

3.2 Default Settings

Before configuring the Wireless AP through WLAN, make sure that the SSID, Channel and the WEP was set properly.

The default setting of the Wireless AP that you will use:

ƒUser: admin

ƒPassword: admin

ƒIP Address: 192.168.1.1

ƒSubnet Mask: 255.255.255.0

ƒWep Encryption: disable

ƒSSSID: default

ƒChannel:6

3.2.1 Password

When there is a screen needs to enter the Network password, it means that there is a password settle, type in the password you entered before.

3.2.2 LAN WLAN

The parameters of LAN and WLAN ports are pre-set in the factory. The default values are shown below.

LAN

 

WLAN

IP address

192.168.1.1

Channel=6

Subnet Mask

255.255.255.0

SSID=default

 

 

Encryption=none

 

 

 

3.3 Accessing the Access Point Web Configurator

Before you configure this device, note that when the AP is configured through an Ethernet connection, make sure the manager PC must be set on same the IP network. For example, when the default network address of the default IP address of the AP is 192.168.1.1, then the manager PC should be set at 192.168.1.x (where x is a number between 2 and 254), and the default subnet mask is 255.255.255.0.

Open Internet Explorer 5.0 or above Web browser.

Enter IP address http://192.168.1.1 (the factory-default IP address setting) to the address location.

A02-AP1-W54

Pag. 13