
Wireless
A.1.3 LED WLAN
The WLAN LED on the front panel does not light up.
Steps | CORRECTIVE ACTION |
1Press the “Reset” button on the rear panel of the AP, to set back to factory default setting.
2Please unplug AC Adaptor and
3If these steps fail to correct the problem, contact your local distributor for assistance.
A.2 WEB
I cannot access the web configurator.
Steps | CORRECTIVE ACTION |
1Make sure you are using the correct IP address of the
Wireless
2Check Mac Filtering (on Security). Access Control function allows clients whose MAC addresses in the list will be able to connect to this Access Point. When this function is activate, there is no wireless clients will be able to connect to the Access Point unless they are listed in the Access Control list.
3Press the “Reset” button on the rear panel of the AP, to set back to factory default setting.
The web configurator does not display properly.
Steps | CORRECTIVE ACTION |
1Make sure you are using Internet Explorer 5.0 and later versions.
2Delete the temporary web files and log in again.
In Internet Explorer, click Tools, Internet Options and then click the Delete Files ... button.
When a Delete Files window displays, select Delete all offline content and click OK. (Steps may vary depending on the version of your Internet browser.)
A.3 Login
If you forget the password to log in
Steps | CORRECTIVE ACTION |
1The Reset function is to reset the setting back to factory default setting, once you press the “RESET” button within 10
Pag. 39 |