IP Wireless Security Camera

sure to set the SSID of the camera to correspond with the access point’s SSID for communication. Type any string up to 32 characters long (spaces, symbols, and punctuation are not allowed) in the Network Name box. To connect the camera to an Ad-Hoc wireless workgroup, make sure to set the same wireless channel and SSID to match with the PC/Notebook’s configuration for direct wireless communication.

•Wireless Channel: This pull-down menu provides the wireless channel for communication. A "channel" is a range of frequencies to be used in communication between the camera and access point in Infrastructure mode, or the camera and PC/Notebook in Ad-Hoc mode. Select the appropriate channel from the list provided depending on the regulatory region where the unit is sold. The default setting is at channel 11.

•Transmission Rate: Select the data transmit rate from this pull-down menu. The default setting is Fully Automatic.

-WEP Encryption

•WEP Encryption: Wireless network communications can be intercepted easily. WEP (Wired Equivalent Privacy) is an encryption method specified by the IEEE 802.11g standard to make any intercepted communications extremely difficult to interpret by unauthorized parties. The default setting for this option is Disable.

•WEP Key Format: To enable WEP Encryption, you should decide the encryption format first by selecting the ASCII or HEX option, and then input the WEP key (in the following Key 1~4 box).

•Encrypt Data Transmissions Using: Use this pulldown menu to decide to use Key 1, 2, 3 or 4 for encryption).

-WAP-PSK

•Preshared Key: Please put a key (8-63 ASCII).

-Advanced Setting: In this field, you can setup more advanced configuration.

•Beacon Interval: This option defines time interval between two images sent.

•Preamble: A preamble is a signal used in wireless environment to synchronize the transmitting timing including Synchronization and Start frame delimiter. Please NOTE that if you want to change the Preamble type into Long or Short, please check the setting of access point.

•Authentication Type: Open System communicates the key across the network. Shared Key allows communication only with other devices with identical WEP settings. The default setting is Both.

ASCII input format:

ASCII format causes each character you type to be interpreted as an eight- bit value. All unaccented upper-and lower-case Western European characters that can beinput through your keyboard's typing zone are valid. To setup a 64-bit WEP key, input 5 ASCII characters. For example, ‘12345’. To setup an 128-bit WEP key, input 13ASCII characters. For example, ‘1234567890123’. Thesecharacter counts result in bit counts of 40 and 104 respectively; the camera will automatically pad your input to a bit count of 64 or 128.

HEX input format:

Hex format causes each pair of characters you type to be interpreted as an eight-bit value in hexadecimal (base 16) notation. Only the digits 0 through 9 and the letters A through F (in upper or lower case) are valid. To setup a 64-bit WEP key, input 10 HEX format. For example, ‘3132333435’, which is the same with ASCII input ‘12345’. To setup an 128-bit WEP key, input 26 HEX format. For example, ‘31323334353637383930313233’, which is the same with ASCII input ‘1234567890123’. These character counts result in bit counts of 40 and 104, respectively; the Wireless Internet Camera will automatically pad your input to a bit count of 64 or 128.

A02-IPCAM-W54_ME01

4