Atlantis Land A02-RA340, A02-RA440 For Windows NT4.0

WebShare 340/440

For Windows NT4.0

1.Go to Start / Settings / Control Panel. In the Control Panel, double-click on Network and choose the Protocols tab.

2.Select TCP/IP Protocol and click Properties.

3.Select the Obtain an IP address from a DHCP server radio button and click “OK”.

Contents

USER’S MANUAL Where solutions begin Page Copyright Disclaimer CHAPTER Page Page Introduction 1.1 An Overview of the ADSL2+ VPN Router 1.2 Package Contents 1.3 ADSL2+ VPN Router Features Firewall: VLAN: QoS: Domain Name System (DNS) relay: Dynamic Domain Name System (DDNS): Dynamic Host Control Protocol (DHCP) client and server: Static and RIP1/2 Routing: SNTP: SNMP: Web based GUI: 1.4 ADSL2+ VPN Router Application 2.1 Cautions for using the ADSL2+ VPN Router 2.2 The Front LEDs 2.3 The Rear Ports 2.4 Cabling ADSL Led Configuration, WAN Connection Mode Apply Save Config to Flash Page Configuration 3.1 Before Configuration 3.2 Connecting the ADSL2+ VPN Router 3.3 Configuring PC in Windows For Windows 95/98/ME DNS Configuration Disable DNS “OK” For Windows NT4.0 For Windows Page For Windows XP Page 3.3.1 Configuration Check 3.4 Factory Default Settings 3.4.1 Username and Password 3.4.2 LAN and WAN Port Addresses 3.5 Information from the ISP 3.6 Configuring with the Web Browser 3.6.1 STATUS ARP Table DHCP Table vance 3.6.2 Quick Start Guide 3.6.3 CONFIGURATION 3.6.3.1 LAN 3.6.3.1.1 Bridge Filtering 3.6.3.1.2 Ethernet 3.6.3.1.2.1 IP Alias 3.6.3.1.3 Ethernet Client Filter 3.6.3.1.4 Port Setting 3.6.3.1.4 DHCP Server DHCP Server Next DHCP Relay Agent DHCP Server: Disable: 3.6.3.2 WAN 3.6.3.2.1 ISP PPPoE(RFC 2516) or PPPoA(RFC 2364) Authentication Protocol Type: Always on: Connect to Demand: Idle Timeout: Detail: RFC 1483 Routing or IPoA routed(RFC1577) BRIDGE (PPPoE) 3.6.3.2.2DNS 3.6.3.2.3 ADSL 3.6.3.3 System 3.6.3.3.1 Time Zone 3.6.3.3.2 Remote Access 3.6.3.3.3 Firmware Upgrade 3.6.3.3.4 Backup/Restore 3.6.3.3.5 Restart 3.6.3.3.6 User Management Cancel 3.6.3.4 Firewall 3.6.3.4.1 General Settings Firewall Security All blocked/User-defined: High, Medium and Low security level: 3.6.3.4.2 Packet Filering Add TCP/UDP Filter: Add Raw IP Filter: Packet Filter Rules: Delete Rule Name: Protocol Number: 3.6.3.4.3 Intrusion Detection 3.6.3.4.4 Url Filtering Block Mode: Disabled Disabled: Always On: TimeSlot1 ~ TimeSlot16: 3.6.3.4.5 Firewall Log 3.6.3.5 VPN 3.6.3.5.1 VPN - PPTP An Example of Configuring a Remote Access PPTP VPN Dial-inConnection Application Diagram Configuring PPTP VPN in the Office LAN Router Page Page Page An Example of Configuring a Remote Access PPTP VPN Dial-outConnection An Example of Configuring a LAN-to-LANPPTP VPN Connection Configuring PPTP VPN in the Office Lan Configuring PPTP VPN in the Remote Lan DDNS Refer also to Configuring PPTP VPN in the Office LAN for other parameters 3.6.3.5.2 VPN - IPSec DES 3DES AES (128, 192 and 256) NULL DES: Advanced Optino IKE (Internet key Exchange) Mode: Hash Function: Diffie-Hellman Group: Content: Identifier: SA Lifetime: An Example of Configuring a LAN-to-LANIPSec VPN Connection Page 3.6.3.6 QoS 3.6.3.6.1 Prioritization 3.6.3.6.2 Outbound IP Throttling (LAN to WAN) 3.6.3.6.3 Inbound IP Throttling (WAN to LAN) 3.6.3.7 Virtual Server Edit DMZ Host NAT Type: Global IP Address: Add Entry Global IP: Global IP Address 3.6.3.8 Time Schedule 3.6.3.9 Advanced 3.6.3.9.1 Static Route 3.6.3.9.2 Dynamic DNS 3.6.3.9.3 Check Emails 3.6.3.9.4 Device Management Embedded Web Server Universal Plug’n’Play SNMP Access Control 3.6.3.9.5 IGMP 3.6.4 Save Config To Flash 3.6.5 Logout Technical Features APPENDIX B Traffis Shaping Support