
Wireless 108Mbps
•1 Antenna: 1 x 2 dBi Dipole detachable Antenna1 (SMA)
•1 port Fast Ethernet: A fast Ethernet 10/100Mbps port is supported in the LAN site and automatic switching between MDI and
•Mac Filtering (ACL): Access Control function allows clients whose MAC addresses in the list will be able to connect to this Access Point.
•Web based GUI: supports web based GUI for configuration and management. It is
•Firmware Upgrade: the device can be upgraded to the latest firmware through the WEB based GUI.
1.4System Requirements
Before installing the device, your PC should meet the following:
Intel® Pentium®III 600Mhz or compatible processor with TCP/IP stack
Iinternet Explorer V6.0 on Netscape V6.0
CDRom
1.5 Setup
The setup of the Wireless Access Point can be performed using the following steps:
•Visually inspect the Ethernet RJ45 port connector and make sure that it is fully plugged in to the system’s Ethernet switch/hub port.
•Fix the direction of the antennas. Try to place the AP in a position that can best cover your wireless network. Normally, the higher you place the antenna, the better the performance will be. The antenna’s position enhances the receiving sensitivity.
•Visually inspect if the Power Adapter was fully plugged to the device power jack.
Pag. 3 |