Wireless 108Mbps Multi-Function Access Point

A.1.3 LED WLAN

The WLAN LED on the front panel does not light up.

Steps

CORRECTIVE ACTION

1Press the “Reset” button on the rear panel of the AP, to set back to factory default setting.

2Please unplug AC Adaptor and replug-it.

3If these steps fail to correct the problem, contact your local distributor for assistance.

A.2 WEB

I cannot access the web configurator.

Steps

CORRECTIVE ACTION

1Make sure you are using the correct IP address of the

Wireless Multi-Function Access Point. Check the IP address of the Access Point (192.168.1.1).

2Check Mac Filtering (on Security). Access Control function allows clients whose MAC addresses in the list will be able to connect to this Access Point. When this function is activate, there is no wireless clients will be able to connect to the Access Point unless they are listed in the Access Control list.

3Press the “Reset” button on the rear panel of the AP, to set back to factory default setting.

The web configurator does not display properly.

Steps

CORRECTIVE ACTION

1Make sure you are using Internet Explorer 5.0 and later versions.

2Delete the temporary web files and log in again.

In Internet Explorer, click Tools, Internet Options and then click the Delete Files ... button.

When a Delete Files window displays, select Delete all offline content and click OK. (Steps may vary depending on the version of your Internet browser.)

A.3 Login

If you forget the password to log in

Steps

CORRECTIVE ACTION

1The Reset function is to reset the setting back to factory default setting, once you press the “RESET” button within 10

A02-WAP-54G

Pag. 39