ENGLISH
1.8 Hardware Installation
Following is a quick installation guide to get you up and running. For further details on each of the settings, please refer to manual on CD.
∙Release two screws from the back side.
∙Remove the aluminium plate.
∙Release the 4 screws in the Hard Disk Mount.
∙Place the first Hard Disk in to lower mont.
∙Place the second Hard Disk in the upper area.
∙Fasten all Hard Disk screws.
∙For SATA Hard Disk: connect both power cable and data cable in
to Hard Disk. For Eide Hard Disk: connect pwer cable and IDE cable in to Hard Disk, set jumper in Master mode and Slave mode when install 2 HD.
∙Slowly put the Hard Disk mount back to case.
∙Fasten the 4 screws.
∙Fasten the Aluminium plate screws.
∙Please use the ethernet cable to connect the device and the Router/Switch in the network.
∙Please turn on the Power Switch.
Please check the following pictures.
DiskMaster | 40 |