￿￿￿&& !￿￿￿&￿￿￿!￿

Source Side

Method A: Push-in Button

1.Use the up/down button to select which input is chosen upon the output (￿) increase (￿) decrease

Method B: IR Remote Control

a. Please press F1 to F6, Enter (), and Exit () button to enter IR control mode and decide which output port to be controlled (see the table below). Or you can use up (￿) and down (￿) button to enter IR control mode and select the output port in ascending and descending order respectively. Whenever you press an IR key to the matrix, the LED display of Port 1 will have a little dot on the lower-right corner lights up to indicate that the matrix receives the IR command.

Note

F1

 

HDMI output port #1

 

 

 

F2

 

HDMI output port #2

 

 

 

F3

 

HDMI output port #3

 

 

 

F4

 

HDMI output port #4

 

 

 

F5

 

HDMI output port #5

 

 

 

F6

 

HDMI output port #6

 

 

 

Enter (

)

HDMI output port #7

 

 

 

Exit (

)

HDMI output port #8

 

 

Up (￿)

Switch output port in ascending order

 

 

Down (￿)

Switch output port in descending order

 

 

 

b.Use left (￿) or right (￿) button to select input source as indicated by the LED display on the front panel for the input channel. The setting will be active once the channel switch command is set after a couple seconds.

Note

Right (￿) button to switch input source in ascending order (1, 2, 3, 4, 5, 6, 7, 8, 1, ...)

Left (￿) button to switch input source in descending order (1, 8, 7, 6, 5, 4, 3, 2, 1, …)

12

Page 14
Image 14
Atlona AT-HD88M-SR manual Source Side, Method a Push-in Button, Method B IR Remote Control