
'+
SW Main for firmware update (for technical support only)
DIP Switch Position | Pin#1 | Pin#2 | Pin#3 | Pin#4 | |
Normal Operation Mode [via | OFF[] | OFF[] | OFF[] | OFF[] | |
|
|
|
|
|
|
Normal Operation Mode [via USB port]7 | OFF[] | OFF[] | OFF[] | ON[] | |
|
|
|
|
|
|
| Block A [main] | ON[] | OFF[] | OFF[] | OFF[] |
|
|
|
|
|
|
Firmware Update Mode8 | Block B [remote] | ON[] | OFF[] | ON[] | OFF[] |
|
|
|
|
|
|
| Block C [HDMI] | ON[] | ON[] | OFF[] | OFF[] |
|
|
|
|
|
|
Note
6Factory default for SW Main is
PLEASE MAINTAIN THIS SETTING AT ANYTIME FOR REGULAR USE VIA
7Factory default for SW Main is
PLEASE MAINTAIN THIS SETTING AT ANYTIME FOR REGULAR USE VIA USB CONTROL!
8Sequence for firmware update
WARNING! [Firmware update only can be done via
1.Power off the
2.Set the pin#1 of [SW Main] at ON[] for firmware update mode.
3.Set pin#2 and pin#3 at respective positions to assign which Block to be updated.
4.Power on the
5.After the OK message shows up to indicate the firmware update sequence for designated Block is complete, please turn off the
6.Repeat step 3 ~ step6 if you want to update the firmware of the remaining Blocks.
7.Set the [SW Main] switch position to Normal Operation Mode.
8.Power on the
8