RS-232
Connection
5 
4 
3 
2 
1
9 
8 
7 
6
No.
1
2
3
4
5
6
7
8
9
Pin | Function |
Not used | |
Tx | Transmit |
Rx | Receive |
Not used | |
Gnd | Ground |
Not used | |
Not used | |
Not used | |
Not used |
Command
The command codes are very sensitive, do not change capitalization, spacing, or lettering.
|
|
|
|
|
| Command | Feedback | Description |
|
|
|
|
|
|
| PWON | PWON | Power on |
|
| PWOFF | PWOFF | Power off |
|
| All# | All# | Resets all inputs to corresponding outputs (input 3 to output 3) |
|
| x1$ | x1$ | Turns off output channel (to turn off output 3 = x3$) |
|
| x1AVx2 | x1AVx2 | Switch input to output (input 3 to output 5 = x3AVx5) |
|
| x1AVx2,x3,x4 | x1AVx2,x3,x4 | Switch input to multiple outputs (input 3 = x3AVx1,x2) |
|
| RS232zoneX[command] | RS232zoneX[command] | Send commands to devices connected to the receiver |
|
|
|
| Commands are the same as the ones stated in this table. |
|
|
|
| X = zone number |
|
| ex: RS232zone1[PWON] | ex: RS232zone1[PWON] | example: Turning the power on for the device connected in zone 1 |
|
| Statusx1 | x7AVx1 | Shows what input is connected to selected output |
|
| Status | x1AVx1, x2AVx2, | Displays which inputs are currently connected to which outputs |
|
|
| x3AVx4, .... |
|
|
| SaveY (ex. Save2) | SaveY (ex. Save2) | Saves settings for future use, saves vary from 0 to 9 |
|
| RecallY (ex. Recall2) | RecallY (ex. Recall2) | Pulls up saved settings for the number you selected |
|
| ClearY (ex. Clear2) | ClearY (ex. Clear2) | Erases the save for the number you selected |
|
| Mreset | Mreset | Sets matrix back to the default settings |
|
|
|
|
|
|
Each command or feedback is terminated with a carriage return.
Note: If the command fails or is incorrect the feedback should be “Command FAILED”
Toll free: | 11 | atlona.com |
Local: |
