Atmel ATAK2270 - page 17

Host Software

5-4 RFID Application Kit ATAK2270 User Manual

4871E–RFID–04/08

5.2.3.1 Write Bit String

The input text box in theWrite Bit String window can be used to enter programming data, which can be

sent to any block. The bit string entered can be freely composed; therefore, it is important to consider the

bit sequence, specified above the text box. For the supported transponder types, typical default configu-

rations can be displayed in the text box by clicking a corresponding Load standand block... buttons.

Clicking the Write button, sends the bit string to the transponder using the write times specified in the

Writing Timing area.

Figure 5-7. Write Bitstring Window

Contents

Main Page Page Section 1 Introduction 1.1 RFID Products Promoted by ATAK2270 Kit 1.2 Included Hardware Components 1.3 Equipment Needed Section 2 Getting Started 2.1 Hardware Settings and Connector Positions Page 2.2 Software Installation Section 3 Description of the Application Board System 3.1 System Overview 3.2 Power Supply 3.3 Antenna Interface Page Description of the Application Board System RFID Application Kit ATAK2270 User Manual 3-3 Figure 3-1. Circuit Diagram of the Antenna Interface Page Page Section 4 Basic Transponder Functionality Getting Started 4.1 System Installation 4.2 Checking Simple Transponder Function Section 5 Host Software 5.1 Software Structure 5.2 Start Window Page Page Page 5.3 Transponder Type Software Interface Description Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page 5.4 Operating Common Transponder Features Page Page Headquarters International Product Contact