Atmel ATAK2270 Section 2 Getting Started

RFID Application Kit ATAK2270 User Manual 2-1
4871E–RFID–04/08
Section 2
Getting Started
Build up the RFID reader application system according to the configuration shown on the cover and in
Figure 2-1:
1. Plug the antenna into the socket of the interface board.
2. Connect a serial RS232 cable between the RS232 connector and either COM1 or COM2 of the PC.
3. Connect the supply line from the 12V power source to the jack connector. Alternatively use the
mains SMPS.
2.1 Hardware Settings and Connector Positions
The main board with the AVR® ATmega8515L controls piggiybacked reader interface and maintains the
communication with the host. On delivery the AVR is fleshed with the current firmware and does not
need any special programming or settings. Check that jumper J3 on the antenna interface is in the
default position en.
Figure 2-1. Application Board Unit