4.4 Ethernet port configuration panel
The Ethernet panel is used to configure the communication parameters for the Ethernet link on the FibreBridge. Some parameters will be “grayed out” if they do not apply to your model of the FibreBridge or if they have no effect based upon the selected value of a related parameter.
DHCP Server (default = Auto detect)
The FibreBridge Ethernet port is capable of receiving its IP address from a DHCPP Server. Select “DHCP” to enable this capability. If autodetect is selected, the FibreBridge will use the ID address entered using IP Address.
Ethernet Speed (default = Automatic Detection)
Configures the Ethernet port on the FibreBridge to either
IP Address (default = 10.0.0.1)
Sets and displays the current IP address of the FibreBridge. If DHCP is enabled, this field will display the IP address assigned by the name server.
IP Gateway (default = 0.0.0.0)
Sets and displays the current IP Gateway of the FibreBridge.
IP Subnet Mask (default = 255.255.255.0)
Sets and displays the current IP Subnet Mask of the FibreBridge. If DHCP is enabled, this field will display the Subnet Mask assigned by the name server.
Some options will be “grayed out” on the panel: they are not available because of the type of access mode or FibreBridge model or they have no effect based on other
selections. The chart below shows options available based on model and access method.
Model/Access method | 2200/3200 | 2200/3200 | 2200/3200 | 4500 | 4500 | 4500 |
Options | Ethernet | serial port | Ethernet | serial port | ||
|
|
|
|
|
|
|
DHCP Server | ● | ● | ● | ● | ● | ● |
|
|
|
|
|
|
|
Ethernet Speed | ● | ● | ● | ● | ● | ● |
|
|
|
|
|
|
|
IP Address | ● | ● | ● | ● | ● | ● |
|
|
|
|
|
|
|
IP Gateway | ● | ● | ● | ● | ● | ● |
|
|
|
|
|
|
|
IP Subnet Mask | ● | ● | ● | ● | ● | ● |
|
|
|
|
|
|
|
13 ATTO Technology BridgeTools Installation and Operation Manual
