AudioQuest M-27 specifications Connections to Printer, Sample Printouts

Parallel Printers

printer. Check printer manual to set up printer. If switches are changed it may be necessary to reset the Check interconnecting cable to assure it is the proper cable.

Set the internal switches in the M-27 to agree with the printer. It is not necessary to reset the M-27 if switches are changed.

Connections to Printer

1.Make sure printer is set up to agree with M-27.

2.Connect printer cable to printer.

3.Turn on printer.

5.Connect printer cable to M-27. Cable goes toward top of M-27 with red strip in middle of unit.

After data is accumulated, a printer is connected to the M-27 and the stored data is printed (see Figure 9). The printer may be used while the M-27 is still gathering data to obtain intermediate results. No data is lost in either unit until the unit is reset.

All the data may be printed, or only selected data if desired. It is possible to change the printout in the middle to obtain, for instance, a 10-minute histogram for part of the time and a 1-minute histogram for another.

The M-27 remembers previous PRINT keystrokes and will print only that data unless the keystroke has been cleared.

Sample Printouts

Heading

A heading is printed when PRINT is pressed. It allows the user to write in identification data (see Figure 10).

Summary

The summary data includes parameter data of how the M-27 is set up and a summary of all the M- 27 functions (see Figure 11).

Events

The event data is printed for events with data. It includes start time, run time, peak and max levels as well as accumulated data for all three dosimeters (see Figure 12).

Histograms

Three separate histograms are computed as the data is accumulated with the appropriate exchange rate and excluding data less than the threshold. Each minute an integrated average level is computed and stored (see Figure 13).

For example, in the following histogram