Operational Details
1. Zone Select Switch
Use labeling kit for zone identification. Press in to send music to the zone controlled by each switch.
2. Input Terminal
Connects speaker cable from amplifier to AE4SW unit.
3. Pass Through Terminal
Connects speaker signal to other
4. Power Protection Circuit Switch
Read Installation Precautions section of this manual for full instructions regarding the use of this switch.
5.Zone
6.Zone
Installation Precautions
•Never place the AE4SW where it would be exposed to excessive moisture or heat.
•Allow for a minimum of 1 inch of clearance above the top of the unit.
1 inch (25mm) Space Above
Installation Precautions (continued)
•Under no circumstances turn off the power protection circuit unless your amplifier can handle the combined impedance of all zones activated.
For example:
With the power protection circuit switch in the “OFF” position, an AE4SW with four pairs of 8 ohm speakers connected will present the amplifier with a 2 ohm load per channel. This may damage your amplifier or cause it to shut down.
With the power protection circuit switch “ON”, an AE4SW with four pairs of 8 ohm speakers connected will present the amplifier with a 6 ohm load per channel which will not present a problem for most amplifiers.
Consult your authorized dealer and/or the owner’s manual for your amplifier for complete details.
•Power handling without the protection circuit switch engaged is 140 watts per channel.
•Power handling with the protection circuit switch engaged is 70 watts per channel.
Total Zones | Protection | Power Capacity |
Connected | Switch | Per Channel |
May Be Off | 140 Watts | |
Must Be On | 70 Watts | |
May Be Off | 140 Watts |
IF USING AE100VC IMPEDANCE MATCHING
VOLUME CONTROLS IN EACH ZONE
1
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| ZONE 1 | ZONE 2 | ZONE 3 | ZONE 4 | |||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
AE4SW dimensions: 8-1/2” x 4-1/2“” x 1-3/4” (216 x 115 x 45mm)
2
3
+-
| INPUT | PROTECTION |
| CIRCUIT | |
|
| SWITCH |
|
| ON |
| OUTPUT | OFF |
- | + | WARNING |
READ INSTRUCTIONS BEFORE | ||
|
| DISABLING PROTECTION |
4
ZONE 3
ZONE 4
+ - - +
5
ZONE 1
ZONE 2
+ - - +
6
Two Year Limited Warranty
AudioSource a division of Peak Audio Group, llc, warrants this product against defects in materials and workmanship for a limited period of time. For a period of two
(2) years from date of original purchase, we will repair or replace the product, at our option, without charge for parts. Customer must pay for all labor charges associated with the removal and
Consumers are required to provide a copy of the original sales invoice from an authorized AudioSource Retailer or Distributor when making a claim against this limited warranty. This limited warranty only covers failures due to defects in materials or workmanship that occur during normal use. It does not cover failures resulting from accident, fire, flood, misuse, abuse, neglect, mishandling, misapplication, alteration, faulty installation, modification, service by anyone other than AudioSource, or damage that is attributable to Acts of God. It does not cover costs of transportation to AudioSource or damage in transit. The customer should return their defective product, freight prepaid and insured, to AudioSource only after receiving a Return Authorization.
Repair or replacement under the terms of this warranty does not extend the term of this warranty. Should a product prove to be defective in workmanship or material, the consumer's sole remedies will be repair or replacement as provided under the terms of this warranty. If the defective product is discontinued AudioSource may replace the product with an equivalent or superior product at its option. Under no circumstances shall AudioSource be liable for loss or damage, direct, consequential or incidental, arising out of the use of or inability to use the product. There are no express warranties other than described above.
