UNIVERSALINSTALLATIONANDIMPORTCARINSTALLATION
4.WiretheRadiototheVehicle'sWiring:
A.Place radio in front of dashboard opening so that wiring can be brought through the mounting sleeve.
B.Carefully follow the diagrams on pages 8 and 9 or 10 to wire the radio, making certain all connections are secure and insulated with wire nuts or electrical tape to insure proper operation of the unit.
C.After completing the wiring,
D.Once proper operation is achieved, turn off ignition switch, remove front panel, and proceed with final mounting of the radio.
5.InstallingtheRadiointheMountingSleeve:
A.Carefully slide the radio into the mounting sleeve until it is fully seated and the side spring clips snap in place.
B.Attach one end of the perforated strap (supplied) to the screw stud on the rear of the radio using the hex nut provided.
C.Fasten the other end of the perforated strap to a secure part of the dashboard either above or below the radio using the screw and hex nut provided.
CAUTION: The rear of the radio must be supported with the strap to prevent possible damage to the dashboard from the weight of the radio or improper operation of the radio due to vibration.
D.
6.RemovingtheRadio:
A.Should it be necessary to remove the radio for servicing or other reasons, first remove the detachable front panel.
B.Remove the rear support strap by taking off the hex nut securing it to the screw stud on the rear of the chassis.
C.Use the 2 removal tools (supplied) to disengage the spring clips and pull the radio out of the mounting sleeve.
HEXNUT
PERFORATEDSTRAP
BENDTOP
TABSUPWARD
BENDBOTTOM
TABSDOWNWARD
SCREWSTUD
HEXNUT
BENDTABSTOSECURE
SLEEVETODASH
SLIDERADIOINTOSLEEVE
UNIVERSAL INSTALLATION AND IMPORTCARINSTALLATION
4
5 of 20
