Audiovox ACD-32A manual Chevrolet-Olds-Buick-Pontiac-Gmc

CHEVROLET-OLDSMOBILE-BUICK-PONTIAC-GMC-CADILLAC-SATURN INSTALLATION AllU.S.MadeCars,Trucks,andVansBuiltSince1982

Important-This radio cannot be installed in any "GM" vehicle without an installation kit. Refer to Kit Listings on page 2 for the required kit. Complete kit installation is explained in the instructions included with kit. This radio cannot be installed in GM vehicles built before 1982.

CAUTION: 1. DO NOT CUT OR FILE THE OPENING TO THE OUTER EDGES OF THE TEMPLATE!

2.FOR PROPER OPERATION OF THE CD PLAYER, THE CHASSIS MUST BE WITHIN 20° OF HORIZONTAL. MAKE SURE THE UNIT IS MOUNTED WITHIN THIS LIMITATION.

1.RemoveExistingRadio:

A.Remove existing radio dash trim panel surrounding the radio opening. This panel is usually secured by screws and/or snap-in clips.

B.Remove the screws used to secure radio to the sub-dashboard.

Helpful Hint: If you do not have an existing radio, you will find the radio opening is covered by a disposable cover plate.

C.Pull the radio forward to access the wiring and antenna cables plugged into the rear of the chassis.

D.Un-plug the wiring harness(es) and antenna cable and remove the radio.

2.InstalltheNewRadio:

A.Following the instructions included with the installation kit, secure the sleeve from the radio to the mounting plate from the kit as explained on page 3.

B.Install the sleeve/mounting plate assembly to the sub-dashboard as per the instructions with the installation kit.

C.Replace the dashboard trimpanel.

D.Following the instructions of steps 4 and 5 on page 4, carefully wire the radio and complete installation into the mounting sleeve.

CHEVROLET-OLDS-BUICK-PONTIAC-GMC-

IMPORTANT

AMOUNTINGKITISREQUIRED

FORTHISINSTALLATION

SUB-DASHBOARDINSTALLRADIOUSINGSAME

(RADIOAREA)PROCEDUREASEXPLAINED ONPAGES3AND4

MOUNTINGPLATEFROMKIT (NOTINCLUDEDWITHRADIO)

FACTORYDASHPANEL

MOUNTINGSLEEVE

REMOVALTOOLS

RADIO

DETACHABLEFRONTPANEL

CADILLAC-SATURN INSTALLATION 6

128-5272

7 of 20