CHARGING THE BATTERY

The TRC-8500 rapid charger will both power the phone and charge the battery simultaneously. The unit attach- es directly to the phone. Charging time will vary depend- ing on the battery’s initial capacity at the beginning of the charge.

1. Attach the battery pack to the phone.

2. Insert plug into AC wall outlet.

3. Plug in the interface connector by gently inserting it into the appropriate contacts on the bottom of the phone.

4.LED will light RED during charging and turn to GREEN when the battery is fully charged.

5.The phone can be operated while the battery is charging.

6.To remove the TRC-8500 from

your phone, press the release buttons on the sides of the interface connector and slide it away from the phone.

7. After recharging, the battery pack may become a little warmer. This is normal.

NOTE: 1. The battery is not charged at the time of purchase.

2. Fully charge the battery before use.

CHARGINGCHARGING THETHE BABATTERTTERYY

NOTE: 1. It is more efficient to charge the battery with the cell phone off.

2.The battery must be connected to the phone in order to charge it.

3.If the LED flickers while charging.

May need cleaning or there may be a problem with the battery.

4.Battery operating time gradually decreases over time.

5.If the battery fails to perform normally, you may need to replace the battery.

BATTERY CHARGING TIME

Battery Type

BTR - 8500

Charging Time

240 minutes

NOTE: Charging time applies only when your phone is turned off. Charging time may vary if your phone is turned on.

BATTERY TALK AND STANDBY TIMES

 

 

Standard Battery

 

 

(900mAh)

Talk Time

Digital

190

(min)

Analog

90

 

Standby

Digital

150

Time

Analog

12

(hrs)

NOTE: These times are for a new battery. Talk and standby time may decrease over time.

Page 14 - Chapter 1

Chapter 1 - Page 15

Page 10
Image 10
Audiovox CDM-8500 owner manual Charging the Battery, Battery Charging Time, Battery Talk and Standby Times