Invacare Ranger X Group 22 Battery Base Frames Figure, Remove battery terminal caps from battery

PROCEDURE 9 BATTERIES

Group 22 Battery Base Frames (FIGURE 3)

NOTE: Refer to WARNINGSand CAUTIONS in the front of this procedure.

BNOTE: Note polarity of white battery cable (jumper) A battery terminal ends.

T	1. Remove battery terminal cap(s) from battery
T
	terminal(s) ends. Refer to DETAIL “A” in FIGURE
E
	3.
R
	2. Connect WHITE battery cable (jumper) NEGATIVE
I
	N	terminal end to NEGATIVE (-) battery terminal/

Epost of front battery and connect POSITIVE P ter-

S minal end to POSITIVE (+) battery terminal/post of

rear battery.

3. Place battery top upside down on top of rear bat- tery.

4. Connect NEGATIVE (-) BLACK battery cable of the battery box top to NEGATIVE (-) battery termi- nal/post of rear battery.

5.Position battery box top right side up and rotate outward toward right to expose POSITIVE (+) bat- tery terminal/post of front battery.

6.Connect POSITIVE (+) RED battery cable on battery box top to POSITIVE (+) battery terminal/post of front battery.

7.Replace battery terminal cap(s) onto battery cable terminal end(s).

8.Rotate top toward left into position. Secure in place.

9.Install the battery box into the wheelchair. Refer to INSTALLING/REMOVING 22NF BATTERY BOX in the Owner’s Manual supplied with the chair.

NOTE: New Battery(ies) MUST be fully charged BE- FORE using, otherwise the life of the battery(ies) will be reduced.

10.If necessary, charge the battery(ies). Refer to CHARGING BATTERIES in the Owner’s Manual supplied with the wheelchair.

44