PROCEDURE 17 | FWD WHEELCHAIRS |
|
|
9.Adjust angleoffootrest.RefertoFOOTRESTANGLE ADJUSTMENTS in this procedure of the Manual.
F10. Install the seat. Refer to REMOVING/INSTALLING
WTHESEATFRAMEinPROCEDURE6ofthismanual.
D11. Install NEW front shroud and existing rear shroud.
WRefer to REMOVING/INSTALLING THE REAR
SHROUD and REMOVING/INSTALLING THEH
E | FRONT SHROUD in this procedure of the Manual. |
E | 12. Install the two (2) end caps provided into the ends of |
L | theseatframewherethetelescopingfrontriggingsup- |
Cports were mounted.
H
A13. Adjust footboard. Refer to DEPTH/HEIGHT/ANGLE
IADJUSTMENT in this procedure of the manual.
R | Mounting |
S | |
Mounting | Screws |
Screw (STEP 6) | (STEP 7) |
| Washer |
| 90o Footrest |
| Support |
| 90o |
| Footboard |
Flat Screws
Washers
Locknuts
FIGURE 14 - INSTALLING 90o FOOTBOARD
FOOTBOARD ADJUSTMENTS- DEPTH/HEIGHT/ANGLE (FIGURE 15)
WARNING
DO NOT remove detent pin from footrest assembly. Otherwise, injury may result.
Depth
1.Remove the four (4) flat screws, washers and locknuts that secure 90o footboard to the two (2) half clamps.
NOTE:Observetheangleofthefootboard forreinstallation.
2.Move footboardtoone(1)oftwo(2)mountingpositions.
3.Secure the footboard to the half clamps with the four
(4)flatscrews,washersandlocknuts.Securely tighten.
Angle
1.Loosen, but do not remove the four (4) flat screws, washers and locknuts that secure the footplate to the half clamps.
2.Position the 90o footboard to the desired angle.
3.Retighten four (4) flat screws, washers and locknuts.
Height
1.Remove the two (2) hub caps.
2.Remove the mounting screw, washers, caplug washers, and locknut that secure the footboard to the footrest support.
3.Adjust footboard to desired height.
4.Secure the footboard with the mounting screw, washers, caplug washers, and locknut. Tighten mounting screw and locknut to 12 foot pounds. See FIGURE 15 for hardware orientation.
102
