Invacare Ranger X, Arrow INSTALLING/REMOVING Captains VAN Seat Assembly Figure, Torque to 75-inch

SEAT FRAME PROCEDURE 6

3.Perform one (1) of the following:

A.If center frame needs replaced, repeat STEP 2 for opposite side frame and proceed to STEP 4.

B.Ifoppositesideframeneedsreplaced,repeatSTEP 2, then proceed to STEP 6. Otherwise proceed to STEP 6.

4.Removethefour(4)mountingscrewsandlocknutsthat secure the center frame to the support brackets.

5.Secure NEW center frame to support brackets with ex- isting four (4) mounting screws and locknuts. Torque to 156-inch pounds.

WARNING

Both side frames MUST be adjusted to the same mounting hole position to maintain proper weight balance of user and seat frame. If weight is not balanced, injury to the assistant and/or user and damage to the wheelchair may result.

6.Install new/existing side frame(s) into new/existing cen- terframeatthemountingpositionpreviouslynoted.Torque to 75-inch pounds.

7.Perform the instructions outlined in PREPARATIONS FORREMOVING/INSTALLINGSEATFRAME(STAN- DARD FRAME, ADJUSTABLE FRAME, AND CAP- TAINSVAN SEAT)inthisprocedureofthemanual.

INSTALLING/REMOVING CAPTAINS VAN SEAT ASSEMBLY (FIGURE 7)

NOTE:Thisprocedureistobeperformedinconjunctionwith a starting procedure. Proceed to the section that reflects the desired change.

Installing Captains Van Seat

1.Positionthecaptainsvanseatontheseatmountingplates at the position shown in FIGURE 7.

2.Line up mounting holes in the captains van seat frame and the mounting holes in the seat mounting plates.

3.Securethecaptainsvanseattotheseatmountingplates with four (4) mounting screws, and locknuts. Torque to 156-inch pounds.

4.Refer back to the starting procedure to complete the desired change.

Removing Captains Van Seat

1.Removethefour(4)mountingscrewsandlocknutsthat securethecaptainsvanseattotheseatmountingplates.

2.Remove captains van seat from seat mounting plates.

3.Refer back to the starting procedure to complete the desired change.

Captains Van

Seat

Seat Mounting

MountingPlate

Screws

(Torque to 156-

inch pounds)

Base Frame

Seat

Mounting

Plate

Locknuts

FIGURE 7 - REMOVING/INSTALLING CAPTAINS VAN

SEAT ASSEMBLY

REPLACING CAPTAINS VAN SEAT AND/OR CAPTAINS VAN SEAT FRAME (FIGURE 8)

1.Perform the instructions outlined in PREPARATIONS FORREMOVING/INSTALLINGSEATFRAME(STAN- DARD FRAME, ADJUSTABLE FRAME, AND CAP- TAINSVAN SEAT)inthisprocedureofthemanual.

2.Removethecaptainsvanseatassemblyfromthewheel- chair. Refer to INSTALLING /REMOVING CAPTAINS VANSEATASSEMBLYinthisprocedureofthemanual.

Captains

Van Seat

Captains

Van Seat

Frame

Washer
Mounting Screw
(Torque to 75-inch	Spacer
pounds)

FIGURE 8 - REPLACING CAPTAINS VAN SEAT AND/

OR CAPTAINS VAN SEAT FRAME

S E A T

F

R A M E

29