RETENTION STRAP/RETAINER | PROCEDURE 11 |
|
|
This Procedure Includes the Following:
Replacing Battery Box Retainer Bar/ Retainer Clip
WARNING
After ANY adjustments, repair or service and BE- FORE use, make sure that all attaching hardware is tightened securely - otherwise injury or dam- age may result.
B.FWD MODEL - Reinstall the mounting screw, washer,spacer,andlocknutthatsecuretheretainer clip to the battery box
5.Reinstall the battery boxes. Refer to INSTALLING/RE-
MOVING BATTERY BOXES - GROUP24 BATTERY BASE FRAMES in PROCEDURE 9 of this manual.
Replacing Retainer Bar
R E T E N T I O N
REPLACING BATTERY BOX RETAINER BAR/RETAINER CLIP - GROUP 24 BATTERY BASE FRAMES (FIGURE 1)
1.Remove the battery box. Refer to INSTALLING/RE- MOVING GROUP 24 BATTERYBOXES in PROCE- DURE 9 of this manual.
Replacing Retainer Clip
1.Perform one (1) the following:
A.RWD AND MWD MODELS - Remove the mounting screw that secures the retainer clip and shock (or rubber element) to the base frame.
B.FWD MODEL - Remove the mounting screw, washer, spacer, and locknut that secure the re- tainer clip to the battery box
2.Remove the existing retainer clip.
3.Perform one (1) the following:
A.RWD AND MWD MODELS - Position the NEW retainer clip between the shock (or rubber ele- ment) and the battery box
B.FWD MODEL - Position the NEW retainer clip between the spacer and the battery box sub- frame as shown in FIGURE 1. Make sure the angled end of the retainer clip is facing upwards.
WARNING
The Battery Box Retainer Bar/Retainer Clip MUST be fastened securely in place before using the wheelchair. Use Loctite 242 and torque to 160- inch pounds.
4.Perform one (1) the following:
A.
1.Perform one (1) the following:
A.RWD AND MWD MODELS
B.FWD MODELS - Remove the two (2) mounting screws, spacers, washers, and locknuts that se- cure the retainer bar to the battery box
2.Pull up on the battery box retainer bar to remove it from the base frame.
3.Installthetwo(2)existingspacersthroughthemounting holes in the NEW battery box retainer bar.
WARNING
The Battery Box Retainer Bar/Retainer Clip MUST be fastenedsecurelyinplacebeforeusingthewheel- chair. Use Loctite 242 and torque to
4.Perform one (1) the following:
A.RWD AND MWD MODELS - Line up the NEW batteryboxretainerbarandspacerswiththemount- ing holes in thebattery boxsubframe andthe base frame.
B.FWD MODELS - Line up the NEW battery box retainerbarandspacerswiththemountingholesin the battery box sub frame.
5.Perform one (1) the following:
A.RWDAND MWD MODELS
B.FWD MODELS - Reinstall the mounting screws thatsecurethebatteryboxretainerbarontobattery box sub frame. Use Loctite 242 and torque to 160- inch pounds.
6.Reinstall theboth batteryboxes.RefertoINSTALLING/ REMOVING GROUP 24 BATTERY BOXES in PRO- CEDURE 9 of this manual.
S T R A P
R E T A I N E R
53
