Audiovox CNP2000UC manual Tools Required, Installation Procedure, Step

Cable Routing/Tools Required/Installation Procedure

6

2.For antenna mounting locations at the front or middle of the roof, the cable can be routed down along the door jam and into the car. In some cars, the cable may be brought into the vehicle through the grommet in the door jam which carries the power window and power lock wires. If the cable does not fit easily through this grommet, do not try to force it through. Instead, route the cable under the weather seal near the lowest part of the trunk to reduce possible water leaks.

3.Use pre-existing wiring channels created by the vehicle manufacturer whenever possible.

Tools Required

The antenna contains a powerful magnet that will secure it to a metal roof under normal driving conditions. No additional tools should be needed to mount the antenna.

Installation Procedure

Step 1

Remove the car stereo head unit from your dash board.

Important: Depending on how your head unit was installed you may have to remove part or all of your dashboard to remove the head unit before the head unit can be pulled out. You may also have to remove screws to complete this step.

Step 2

Connect the cable into the PIA. Plug the other end of the cable into the head unit adapter. Read your cable installation manual for proper installation to your specific head unit.