Audiovox VM9510TS Tv Tuner Operation, Accessing TV Mode, Storing Stations AS, Auto Tuning

VM9510TS

TV TUNER OPERATION

Accessing TV Mode

To switch to TV mode, press the SRC button (8) on the remote control or front panel until TV appears at the bottom of the screen.

NOTE: Touch the top left corner to access the MAIN MENU Multi-ZONE SETUP menu and the top right corner to access the Multi-ZONE menu (rear zone setup).

Auto Tuning

Press the button (19) on remote control, or the button on the joystick (17) to seek the next available TV station by increasing the tuning frequency.

Press the button (17) on the remote control, or the button on the joystick (16) to seek the next available TV station by decreasing the tuning frequency.

Press the /BAND, , , or button to stop searching.

Once a TV station is searched, the auto seeking stops and the TV station is played. If no station is searched, the tuning stops at the first channel after performing a round search.

Manual Tuning

Press the or buttons (16, 17) on the joystick to increase or decrease the TV frequency one step.

Storing Stations (AS)

Automatic Preset Memory

To select the strong stations in the current TV frequency range, press and hold the joystick button (20) to activate the Auto Store function. The new stations replace stations already stored. Press the joystick button again or press the

/BAND button (20) on the remote control to stop searching.

Using Preset Scan

To scan stored stations:

1.Press the joystick button (20) to scan all stored TV sta- tions. The unit pauses for 10 seconds at each station.

2.Press the joystick button again or press the /BAND button (20) on the remote control to stop scanning and play the current station.

Selecting a TV Station

To browse through stored stations:

•Press the button (15) on the remote control, the button (19) on the joystick or the CH- button on the front panel to tune the previous stored station.

•Press the button (22) on the remote control, the button (18) on the joystick, or the CH+ button on the front panel to tune the next stored station.

Direct Channel Selection

Use the numeric keypad on the remote control (29) to enter a specific TV station.

Display Current Channel

Press the DISP button (10) on the remote control to display information regarding the current TV station.

23