Aurora Multimedia ICS-SP20 manual Troubleshooting, Symptom Checks

ICS-SP20 User Manual

If the password is reset, the user is prompted to enter new password on his/her first access to V-Chip limit. For all subsequent accesses the user will have to use the password that was specified during the first access. In the event the password is forgotten the V-Chip settings can reset by holding the enter button for 5 sec. When prompted for the password enter right, left, right, left, enter and it will be reset to default values.

7.10 Troubleshooting

Symptom	Checks
Key on remote is pressed but	See if the upper LED of ICS-SP20 is fast-blinking while
nothing happens	pressing key and aiming remote at IR sensor on the display.
	If it is not -– check the batteries in the remote.
Image is Green	Make certain Option slot is select to YPbPr
No control of the display via	Under panel settings check to see if correct model is
Menus	selected.
No Image	Check to see if Option Slot is selected as source
Cannot switch to a particular TV	The channel is selectable by browsing keys only if it is
channel using channel +/-	marked as “valid”. To be marked as “valid” the channel must
browse keys.	have a good TV signal during the “channel scan” operation.
	Repeat the channel scan (making sure aerial/cable
	connection is good). Also the channel validity can be edited
	manually.

12