10
Prior to performing any further assembly, PERFORM “FIRST TIME USE” LEAK TEST as detailed on pages 17-18.
If the grill is fully assembled b efore performing th e First Time Use leak test, the side t ables will need to be removed in or der to perform the
leak test on the valves behind the k nobs, inside the control panel.
CAUTION
!
Step 10
Side Table Assembly
A. Screw two 1/4-20 x .50” Bolts into the two bottom threaded inserts on the outside of the Bowl. Do not screw Bolt s
all the way. Leave 1/8” of each Bolt exposed.
Align the bottom two holes (“keyhole slots” in detail) on the inner side of the LEFT S ide Table with the two bolts thread-
ed partly into the inserts in the Side of the Bowl then slide the Side B urner Table over the Bolts.
B. Holding the Side Burner Table in place, install two 1/4-20 x .50” Bolts from the inside of the Bowl into the two top
threaded holes in the Side Table.
C. From under the Side Table, install one 5/32 x .31” bolt through the Side Table end into the side of the Bowl.
Repeat this assembly for the RIGHT Side Table. Tighten all bolts.
1/4-20 x .50” Bolt set
8 pc
5/32 x .31” Bolt set
2 pc
BC
A
Keyhole Slots
5/32 x .31” Bolt