Grizzly G1023S instruction manual Beginning Assembly Extension Wings

Beginning Assembly Extension Wings

	Keep clothing rolled up
	and out of the way of
	machinery and keep
	hair pulled back.
!	Disconnect power to the
	machine when perform-
	ing any maintenance or
	assembly. Failure to do
	this may result in serious
	personal injury.

Wear safety glasses dur- ing the entire assembly process. Failure to com- ply may result in serious personal injury.

Some metal parts may have sharp edges on them after they are formed. Please examine the edges of all metal parts before handling them. Failure to do so could result in injury.

TOOLS REQUIRED: You will need a high quality square, a long straightedge, 10mm, 12mm, 14mm open end wrenches and a 3mm Allen¨ wrench.

The table and the wings represent a very heavy load. DO NOT over-exert yourself while lifting or moving the table and the wings – get assistance.

To attach the extension wings to the saw:

1.Attach the left wing to the table using the (3) 3Ú8"-16 x 11Ú4" Hex Bolts and 3Ú8" Flat Washers provided. Adjust the wing reasonably flush with the table and do not tighten the bolts completely at this time.

2.Attach the right wing to the table using the

(3)3Ú8"-16 x 11Ú4" Hex Bolts and 3Ú8" Flat Washers provided. Adjust the wing reason- ably flush with the table and do not tighten the bolts completely at this time.

3.Align the top of the wings flush with the table top directly above the front bolts and flush with the front edge of the table. Tighten the front bolts.

4.Raise or lower the rear of the extension wings until the middle of the wings are flush with the table top. Tighten the middle bolts.

5.Raise or lower the rear of the wings until the wings and table are flush. Tighten the rear bolts.

6.Re-check the flushness of the wings against the table above each bolt. Re-adjust if nec- essary.

G1023S Series Heavy-Duty 10'' Table Saw -17-