Aussie 6804, 6805 manual Step Door Assembly, Step Hood/Body To Cart Assembly

11

Step 10

Door Assembly

Install LEFT Door. Drop bottom door pin into Cabinet Bottom Panel hole. Swing top of door toward hole in top of Left Side Panel. Depress spring-loaded pin with thumb while sliding pin into Left Side Panel hole until it snaps into place.

Right Door assembly is similar; Fixed pin is under drawer and inserts into hole in door and spring-loaded pin is in the BOTTOM of small door and functions the same.

Depress

Left Door shown, Right Door under drawer.

!CAUTION

To reduce the risk of bodily injury from lifting, the following assembly steps #s 11 and 12 will require two people.

Step 11

Hood/Body To Cart Assembly

Lift the Hood/Body Assembly over the cart assembly and set it down until it rests on the inside top flanges of the cart.

Align the holes in the side of the Hood/Body with the holes in the Side Panel brackets. Insert four 1/4-20 x .50 Bolts through the holes in cabinet flanges and into threaded inserts in firebox and tighten after all are installed.

1/4-20 x .50” Bolt set

4 pc

Right side view

NOTE:

Model 6805: Carefully route gas and electrical lines when placing hood/body assembly on cart. Be sure no lines are pinched between hood/body assembly and cart.