Auto Page ACD-94 manual Ct TIME/FREQUENCY Selector T/F, Dn Front Panel Release Button Open

RESET BUTTON

THEFT-DETERRENT LED

EQUALIZER BUTTON (P.EQ)

accidentally damaged ( will appear on the display panel to indicate that a disc is loaded in the player). Play of the disc can be resumed by using the MODE button bt to choose the CD player function.

ct TIME/FREQUENCY SELECTOR (T/F)

During radio operation, press this button to call the time display on the incorporated quartz clock. The current time will appear together with an A or P indication. The display will return to the radio frequency indication after 5 seconds.

During disc play press of this button to call the time display. The display will return to

the disc indication after 5 seconds.

cu

The P.EQ button applies preset sound effects to the unit’s audio output signal.The P.EQ button, when pressed, will activate one of the following operating modes (CLASSICS, POP M, JAZZ, DSP OFF or FLAT). Even though the Equalizer function is active, as displayed on the panel, if the bass and/or treble level is set, the Equalizer function automatically returns to the FLAT mode. Conversely, when the Equalizer function is not active, the unit returns to the user set

bass and treble levels.

dl

Located on the chassis behind the front panel, a light-emitting diode (LED) will flash when the panel is physically removed. The flashing light serves as a visual warning to the would-be thief that the unit has been

disabled by removal of the front panel.

dm

The RESET button is located to the right of the theft deterrent LED. The reset circuitry should only be activated under the following

circumstances as it will erase the time and pre-set memories:

1.Upon initial installation after all wiring is completed.

2.If there is a malfunction of any of the switches on the unit, pressing the RESET button may clear the system and return to normal operation.

dn FRONT PANEL RELEASE BUTTON (OPEN)

This button is used to release the mechanism that holds the front panel to the chassis. To detach the front panel, press the button so that the panel drops to the lowered position. Grasp the panel at the middle, press the RELEASE bar, and pull it off of the chassis. To re-attach the panel, press it straight onto the chassis until the mechanism locks it into place.

do REMOTE SENSOR

The sensor to detect the infrared signal from the wireless remote control is located behind the VFD display lens. For optimum operation of the remote control, always aim the control at the VFD display.

NOTES ON USE OF FRONT PANEL:

1.Make sure the front panel is positioned correctly when attaching it to the chassis as it cannot be attached when up-side down. Use moderate pressure to fully seat the panel into position.

2.To verify correct panel installation, swing the panel assembly up into position until it locks easily into place. If any resistance is encountered, re-check panel orientation in chassis mounting plate.

OPERATING INSTRUCTIONS

11