Auto Page ACD-94 manual Codes / Remote Control Operation, CD Changer Error Codes

CODES / REMOTE CONTROL OPERATION

CD CHANGER ERROR CODES

If a problem should develop while operating the CD changer, the following error codes may appear on the display panel.

ER-1:Indicates that there is no magazine loaded in the CD changer.

ER-2:Indicates a problem with the magazine eject function.

ER-3:Indicates an error in the disc loading function.

ER-4:Indicates an error in the disc un-loading function.

ER-5:Indicates an error in the magazine position.

ER-6:Indicates an error in the laser pick-up position.

ER-7:Indicates an error in the laser focus on the disc.

In any of the above situations, try ejecting the CD magazine from the changer and make sure the discs are clean, undamaged, and loaded correctly (refer to the Owner’s Manual of the CD changer). Re-load the magazine and check for proper operation. You may also try activating the RESET button dm on the unit, but this will also erase the time and pre-set memories.

If the suggested measures do not solve the problem, contact an approved warranty station near you for further assistance.

CD CHANGER ERROR

16

WIRELESS REMOTE CONTROL OPERATION

The wireless remote control supplied with this model is capable of operating most of the features of the unit from a remote location. Each button on the remote control functions in the same way as the referenced button on the main unit. For optimal operation of the remote control,

always aim it toward the Remote Sen-

do

1POWER ON/OFF - See Main Unitsor on the front panel of the main unit.

1.

2MODE SELECTOR (MODE/7) - See Main Unit bt and dp.

3INFRARED SENDER - Emits infra-

red signal to radio which is detected by the sensor do.

4VOLUME (LEVEL) CONTROL- See Main Unit 2, 3 4, 5, 6, and 7 except press to increase level, and press to decrease level.

5SELECT BUTTON (SEL) - See Main Unit

3, 4, 5, 6, and 7.

6TUNE/SEEK (9,8) CONTROL – See

Main bm except pressUnit

to increase frequency, and press to decrease frequency.

MANUAL SEEK TUNING – See Main

Unit bm ,except press to Seek

upward, press to Seek downward.

CD TRACK SELECT – See Main Unit
c l	and	d r	except press

to select a higher track number,

press to select a lower track num- ber.