Avalon Stoves manual Auto Mode, To Adjust Room Temperature or Start the Stove

Operation2 3

Auto Mode

Auto mode allows you to use a thermostat to control room temperature. The stove automatically turns on when the temperature drops below the thermostat setting. Once the stove reaches operating temperature, the stove then runs at the heat output setting selected.

To Adjust Room Temperature (or Start the Stove)

Move the thermostat to the heat setting desired. If the room is cooler than the setting, the stove will go through the start-up sequence for approximately 10 minutes. During this period the lowest “HEAT OUTPUT” light will flash. Once up to temperature, the stove will then run at the heat output setting selected on the control panel. If the room is too hot, move the thermostat to a lesser setting.

To Adjust the Heat

Press the "Heat” buttons to adjust the heat output.

HINT:

If you find that the stove turns on and off repeatedly, you may wish to turn the heat output to a lesser setting. The lower setting will provide a more consistent heat output over time, eliminating the need for the thermostat to repeatedly turn the stove off.

NOTE:

If the thermostat calls for heat while the stove is still cooling down, the stove will go through the start-up sequence (for a minimum of 20 minutes).

	DISCONNECT POWER BEFORE SERVICE
H
E	HIGH
A		AUTO
T
O	MANUAL
U
T	AUGER
P
	LOW
U		MAINT.
T	(REQUIRED)
		AUTO
H	UP	OFF
	MANUAL
E
A
T	DOWN	MANUAL
F	UP	START
A
N	DOWN
		TM
	TRAVIS INDUSTRIES
	HOUSE OF FIRE

These lights indicate the heat output setting.

NOTE: the lights may be difficult to see from an angle.

Press the “up” or “down” button to adjust the heat output.

To Shut Down

Move the mode switch to "OFF". The exhaust blower will still run until the heater cools down.

		AUTO
H	UP	OFF
	MANUAL
E
A
T	DOWN	MANUAL
	UP	START

F

AMANUAL

N

DOWN

AUGER

TM

TRAVIS INDUSTRIES

HOUSE OF FIRE

© Travis Industries 4080725 1 0 0 - 0 1 1 5 4