how to use the top burners

GAS BURNERS

Gas flow to the burners is adjusted by turning the knobs (illustrated in fig. 2.1) which control the valves.

Turning the knob so that the symbol printed on itself points to the symbols printed on the control panel achieves the following functions:

= closed valve

= maximum rate

= minimum rate

The maximum aperture position permits rapid boiling of liquids, whereas the minimum aperture position allows simmer warming of food or maintaining boiling conditions of liquids.

To reduce the gas flow to minimum, rotate the knob further anti-clockwise to point the

indicator towards the position.

Other intermediate operating adjustments can be achieved by positioning the indicator between the maximum and minimum aperture positions, and never between

the maximum aperture and positions.

N.B. When the range is not being used, set the gas knobs to their positions and also close the gas shut-off valve placed on the main gas supply line.

LIGHTING GAS BURNERS

In order to light the burner, you must:

1 – Turn the knob in an anti-clockwise direction up to the position (maximum rate), push in and hold the knob until the flame has been lit (fig. 2.2).

The sparks produced by the lighter situated inside the relative burner will light the flame.

In the event that the local gas supply conditions makes it difficult to light the burn-

er in position, try again with the knob in position.

If there is no mains electrical supply, bring a lighted match close to the burner.

2 – Adjust the gas valve to the desired position.

To re-light the burner, return the knob to the position and repeat the operations for lighting.

Caution!

The range becomes very hot during operation.

Keep children well out of reach.

Fig. 2.1

Fig. 2.2

7

Page 7
Image 7
Avanti DG 2401 C warranty How to use the top burners, Lighting GAS Burners