Avanti WC331DZD Moving Your Appliance, Energy Saving Tips, Problems with Your Appliance

MOVING YOUR APPLIANCE

?Securely tape down all loose items inside your appliance.

?Turn the leveling screw up to the base to avoid damage.

?Tape the doors shut.

?Be sure the appliance stays secure in the upright position during transportation. Also protect the outside of appliance with a blanket, or similar item.

ENERGY SAVING TIPS

?The appliance should be located in the coolest area of the room, away from heat producing appliances, and out of the direct sunlight.

PROBLEMS WITH YOUR APPLIANCE

You can solve many common appliance problems easily, saving you the cost of a possible service call. Try the suggestions below to see if you can solve the problem before calling the servicer.

TROUBLESHOOTING GUIDE

PROBLEM	POSSIBLE CAUSE
Appliance does not operate.	Not plugged in.
	The circuit breaker tripped or a blown fuse.
Appliance is not cold enough.	Check the temperature control setting.
	External environment may require a higher
	setting.
	The door is op ened too often.
	The door is not closed completely.
	The door gasket does not seal properly.
Turns on and off frequently.	The room temperature is hotter than normal.
	The door is opened too often.
	The door is not closed completely.
	The temperature control is not set correctly.
	The door gasket does not seal properly.
The light does not work.	Not plugged in.
	The circuit breaker tripped or a blown fuse.
	The bulb has burned out.
	The switch is in the “OFF” position.
Vibrations.	Check to assure that the appliance is level.
The appliance seems to make too much noise.	The rattling noise may come from the flow of the
	refrigerant, which is normal.
	As each cycle ends, you may hear gurgling
	sounds caused by the flow of refrigerant in your
	appliance.
	Contraction and exp ansion of the inside walls
	may cause popping and crackling noises.
	The appliance is not level.
The door will not close properly.	The appliance is not level.
	The door was reversed and not properly installed.
	The gasket is dirty.
	The shelves are out of position.

13