Avanti WDTZ000 instruction manual Instructions Before Installing Cartridge First USE, Assembly

USE AND CARE 5

ZeroWater® Filter Bottle

Use and Care Instructions

Please read before first use.

INSTRUCTIONS BEFORE INSTALLING CARTRIDGE

AND FIRST USE

1.Clean all plastic components and filter cartridges by washing and rinsing thoroughly with warm water only. Rinse the Filter Bottle thoroughly when washing with soap.

2.Note: the Filter Bottle components, filter cartridges and TDS meter are not dishwasher safe.

3.Discard all plastic bags. This may be a suffocation hazard to young children.

ASSEMBLY

1.Take the lower chamber and place the lower chamber divider rim firmly on the top. The rippled part of the white rim should be overlapping the lower chamber. If assembled upside down, there will be leakage. Be sure it fits tightly

on the lower chamber (see ZeroWater® Filter Bottle components

on page 4).

A2. Align the nut (included) into the recessed area at the inner bottom of the lower chamber and screw the float valve tightly through the hole on bottom of lower chamber (inset A).

Do not prop the Filter Bottle on the float valve once assembled, as it is fragile and will break.

3.Place the lower chamber on top of your cooler with the float valve fitting inside the cooler’s reservoir (see Using Your

ZeroWater® Filter Bottle with a Standard Water Cooler on page 6).

4.Install filter cartridges now, using steps 1 through 3 from instructions on next page.

5.Place the upper chamber on top of the lower chamber. Be sure that the lower chamber divider ring is tightly affixed around the lower chamber (see ZeroWater® Filter Bottle components on page 4).

6.Place the lid on top of the upper chamber.