ATTENTION:
If you do not plan to use the water heating function for more than three days, we recommend that you turn off the hot water function.
OPERATING YOUR WATER DISPENSER
The following steps apply only if you are switching from the Zerowater Bottle Kit to Standard Delivery type water bottles.
Steps To Replace Water Bottles
Remove cap from the
Carefully lift bottle (approx. 40 lbs.) using your legs and not your back. Do not place hands on opening of bottle while placing in reservoir.
Place the
Wipe off any water which may have splashed on dispenser top.
When a new bottle is installed you must open the hot water faucet and remove no less than 4 full cups of water to insure the water flows properly and the water reservoir is at the proper level.
Control and Display Panel
For operation of unit, please fill water and make sure water settles inside the water tank, and then switch on both hot and cold switches at back of unit.
NOTE:
THE HOT WATER FAUCET HAS A CHILD-SAFETY GUARD ATTACHMENT.
To get hot water:
♦ Slide red safety button to the right and hold while pressing downward on hot water faucet to dispense hot water.
♦ Safety button will return to its original position when faucet is released.
NOTE:
THE DISPENSING CAPACITY OF HOT WATER IS APPROXIMATELY 2 ½ CUPS AT A SINGLE TIME. ONCE THE MAXIMUM NUMBER OF CUPS HAS BEEN DISPENSED THE RESERVOIR WILL REFILL AND BE READY TO DISPENSE ANOTHER 2 ½ CUPS IN APPROXIMATELY 5 – 6 MINUTES
8
