TMA; Reviewed:
SPOC 11/16/2009
Solution & Interoperability Test Lab Application Notes
©2009 Avaya Inc. All Rights Reserved.
5 of 10
ProC2520-24PoE
No ProCurve 2520-24-PoE Switch specific configuration is required on Avaya AuraTM
Communication Manager or Avaya IP Office to support this solution.
For additional configuration details, refer to Section [9].
5. Configure the ProCurve 2520-24-PoE Switch The configuration covered here is specific to PoE and does not include configuration of other
features available in the ProCurve 2520-24-PoE Switch. Consult the ProCurve 2520-24-PoE
Switch configuration manual [9] for additional configuration details.
Inline PoE is supported on the ProCurve 2520-24-PoE Switch. By default, PoE support is
enabled on the system and on all ports.
6. General Test Approach and Test Results 6.1. Test Approach
The general test approach was to:
Connect the Avaya IP Telephones to ports on the ProCurve 2520-24-PoE Switch and
verify that the PDs successfully booted.
Power cycle the ProCurve 2520-24-PoE Switch and verify successful boot operation of
the PDs and registration of the telephones.
6.2. Test Results
All Power over Ethernet test cases completed successfully. The ProCurve 2520-24-PoE Switch
successfully provided inline power to all of the Avaya IP Telephones listed in Table2. Table 2
lists the measured power of the Avaya IP Telephones when connected to the ProCurve 2520-24-
PoE Switch. The power listed as measured by the ProCurve 2520-24-PoE Switch is for PDs
under idle conditions.
Note: Cable length and impedance affect power usage, so the measurements listed here may vary
based on the cable used.