Chapter 2 | Installation |
Rack Mounting
P110 switches slot into a standard
Remove the rubber legs from the base of any switch that is to be rack mounted. Place the switches in the rack, and then connect the P110 Exoplane, as follows:
1.Snap open the ends of the front panel to reveal the fixing holes.
2.Slot the switch into the rack. Insert the switches into the rack so that the switches in a logical stack lie directly on top of each other. Ensure that the P110 screw holes are aligned with the rack hole positions exactly as shown in Figure 3. Stacking them in this way will allow the switches to be easily connected using the Exoplane cables.
3.Secure the switch in the rack using the screws. Use one screw on each side. Do not overtighten the screws to avoid damaging the plastic.
4.Connect the Exoplane cables, as described above, and as illustrated in Figure 2.
5.Snap closed the hinged ends of the front panel.
Figure 3 P110 rack mounting arrangement
10 | P114T Stackable Switch Installation Guide |
