Chapter 4 Using the System

1.Select a button from to set up your E-map. When you

click button, the left-top corner will appear “Area 1” in blue. Click to load an E-map. The system supports up to 8 E-maps. The map must have been saved in JPG or BMP format and file size is smaller than 200KB.

2.Click to arrange Cameras, Sensors, and Relays by dragging,

and buttons to the E-map to indicate actual locations of camera, sensor and relay devices. When you drag the camera icon to the desired E-map, the right windows will show images from the appointed camera if the enabled camera is connected to your digital surveillance system.

To delete the buttons, drag them back to the column where they were previously

taken or click to reset all icons. You will see your desired camera image at the right corner.

3.The lower-right column shows the information of cameras, relays and sensors when the system detects a video loss or sensors and relays are trigged. The icons on the E-map will turn red and blink.

Click to save your current setup and leave E-map.

4.6 Using PTZ Camera

If you connect PTZ cameras to your DVR system, click on the Monitor Screen and setup PTZ cameras first. You will see a controller after pressing the button.

Click to configure PTZ cameras as the above picture. A PTZ setup dialog appears.

128