Avery 9493 Note:, Do not, Do not, Do not, do not, Do not

6. Remove the clear wrap from a new ribbon and tear it at the perforation.

B

Take-up Core

A

Gear

New Ribbon

Latches

7. Make sure the preprinted side of the ribbon faces out. Slide the ribbon reel onto the long spool with the foam washer and the take-up reel onto the short spool. Thread the ribbon around the ribbon guide. Turn the ribbon roll slightly to take up some of the excess slack, if necessary.

A

Ribbon

Guide

Foam Washer

Do not wind the ribbon too tightly. Do not touch the ribbon with your fingers. Do not wrinkle or twist the ribbon.

Note: If you are using a 2-inch or 3-inch ribbon, push the core of the ribbon roll onto the spool of the cassette but do not force it or you may damage the foam washer. Do not touch the ribbon with your fingers!

2-4Operator’s Handbook