products designated as
Switch 9 On and Switch 10 On – Test Mode
Mode
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 10 | ||
Stereo Link 
In Test Mode, channels 1 through 4 output a 1kHz, 48k sample rate sine wave. This mode can be used
!to troubleshoot an audio system. Make sure to set the Yamaha console’s internal sample rate to 48k when using Test Mode.
(Note that the DIP switch handles are shown in white.)
When troubleshooting using the Y1 card Test Mode, if the 1kHz test tones are heard in channels 1 through 4 of a connected
Warning: Before switching the Y1 card to Test Mode, lower the volume on any connected
To exit the Test Mode, a console restart is required. Power off the Yamaha mixing console. Reset the Y1 card DIP switches to the desired operational mode position, and then reboot the Yamaha console.
10
