Avocent 3050, 3100, 3200 manual Serial IQ module pinouts, To use History mode

80AutoView 3050/3100/3200 Switch Installer/User Guide

To use History mode:

1.Press Ctrl-F9. The mode will display as History.

2.Press one of the following key combinations to perform the indicated action:

•Home: Move to the top of the buffer.

•End: Move to the bottom of the buffer.

•Page Up: Move up one buffer page.

•Page Down: Move down one buffer page.

•Up Arrow: Move up one buffer line.

•Down Arrow: Move down one buffer line.

•Ctrl-F8: Enters Configuration mode. The Configuration screen will appear.

•Ctrl-F9: While in Configuration mode, returns to the previous screen with History mode enabled.

•Ctrl-F10: While in Configuration mode, returns to the previous screen with On-Line mode enabled.

•Ctrl-F11: Clears the history buffer. If you choose this option, a warning screen will appear. Press Enter to delete the history buffer or Escape to cancel the action. The previous screen will reappear.

3.When finished, press Ctrl-F10to exit History mode and return to On-Line mode.

Serial IQ module pinouts

Table B.1 lists the pinouts for the serial IQ module.

Table B.1: Serial IQ Module Pinouts

DB9-F	Host Signal Name Description	Signal Flow	SRL Signal Name Description
Pin
1	DCD - Data Carrier Detect	Out of SRL	DTR - Data Terminal Ready
2	RXD - Receive Data	Out of SRL	TXD - Transmit Data
3	TXD - Transmit Data	In to SRL	RXD - Receive Data
4	DTR - Data Terminal Ready	In to SRL	DSR - Data Set Ready
5	GND - Signal Ground	N/A	GND - Signal Ground
6	DSR - Data Set Ready	Out of SRL	DTR - Data Terminal Ready
7	RTS - Request to Send	In to SRL	CTS - Clear to Send
8	CTS - Clear to Send	Out of SRL	RTS - Request to Send
9	N/C - Not Connected	N/A	N/C - Not Connected