Avocent KVM over IP switch user manual ¾ 7-Segment Bank LED Indication, Keyboard Hot Key Commands

8/16 PS/2 KVM over IP switch

please put 16 port IP-KVM switch on the 1st bank ( or say Master bank). It is based on 16 port IP-KVM switch supports 16 port LEDs display on the front panel. Otherwise, 8 port IP-KVM switch is allocated at 1st bank and there is a 16 port IP-KVM switch chained to the slave bank, the master bank (or say 1st bank) is unable to show the PC port LEDs (from port 9 to 16) of 16 port IP-KVM switch completely.

¾7-Segment BANK LED Indication

When you would like to view the next bank KVM switch, please press “ BANK “ push button cyclically to the destination bank. The bank LED will be changed from bank 1 to the maximum daisy chain level and then to press “ BANK “ push button once back to the

bank 1.

Bank 1 Bank 2 Bank 3 MAX. BANK

¾ Reset Button ((“ Bank Bank ” button) and (PC 8/16 ” 8/16 button)):

To press both “Bank” button and “any one of the PC1~PC8” button of master bank simultaneously can reset KVM switch. This reset action will not only return KVM switch back to initial state --- Check the password, but also re-check all of slave banks which connected to mast KVM Switch.

If you add a new KVM Switch as a slave bank, please use reset button of master KVM Switch to automatically assign a new ID to it. You can view this new slave bank go through OSD menu. The PC ports of KVM Switch do not be reset by reset command.

Keyboard Hot Key Commands:

You can also conveniently command KVM switch by switching ports through simple key sequences. To send commands to KVM switch, the “SCROLL LOCK” key must be pressed twice within 2 seconds. You will hear a beep for confirmation and the keyboard is in hot key mode. If you have not pressed any key in hot key mode within 2 seconds (It means to key in any key follows up “Scroll Lock” “Scroll Lock” key ), the keyboard will back to under Operation System (O.S.) control state.

Below are the different hot key commands (for local KVM):

within 2 seconds

Scroll	+	Scroll	+	↑	=	Previous Channel
Lock		Lock
Scroll	+	Scroll	+	↓	=	Next Channel
Lock		Lock
						(Note: You also could press “up arrow key” or
						“down arrow key” longer time to speed up
						or speed down selecting the destination
Scroll		Scroll		Page		port)
Lock	+	Lock	+	Up	=	Previous Bank
Scroll		Scroll		Page
Lock	+	Lock		Down	=	Next Bank
+				+

21