AXIS T95A00/T95A10 Dome Housing | Page 5 |
Tools not included
Phillips screw driver
RJ45 crimp tool*
Adjustable wrench
*The RJ45 connector is attached after the cable has been pulled through the cable gland.
Other required parts
Bracket | see www.axis.com for available brackets and accessories |
Power cable | AWG20, |
| AWG22, 24 VAC cable (AXIS T95A10 Dome Housing) |
Network cable | CAT 5 shielded twisted pair (STP) cable recommended |
RJ45 connector |
|
Soft cloth | Recommended for protecting the dome while installing the housing |
Note:
Not all screws provided are required for all camera installations.
Installation
Prepare the following steps indoors before you proceed to do the installation outdoors. This will save time at the installation site.
Top cover | Black | Blue |
| cable | cable |
Universal
Adaptor plate
Attach Universal Adaptor plate to camera
1.Remove the top cover of the housing (with four screws) from the housing using the 3mm allen key.
2.For AXIS T95A00 Dome Housing only - remove the two connectors (with black and blue cables) attached to the power supply on the Universal Adapter plate.
3.Loosen the three screws holding the Universal Adaptor plate. Slightly rotate and remove the Universal Adaptor plate.
4.Attach the Universal Adaptor plate to the camera. For details see page 13.