Assembly
Assembly of the Model G0704 consists of attach- ing the four handwheel handles to the machine.
To assemble your machine:
1.With a #3 standard screwdriver, install the large handwheel handle on the elevation handwheel (Figure 12).
Elevation
Handwheel
Elevation
Handwheel
Handle
Figure 12. Elevation handwheel handle.
2.use the same method to install the three small handwheel handles to the three table travel handwheels (Figure 13).
Figure 13. Table handwheel handles.
Model G0704 (Mfg. Since 08/11)
Drill Chuck Arbor
Your machine includes an
Tip: For a permanent installation, chill the arbor in the freezer for 15 minutes before performing the following procedure. The taper will expand as it returns to room temperature, permanently locking the chuck.
To install the drill chuck onto the arbor:
1.Clean the grease off the drill chuck and all taper mating surfaces. Pay particular atten- tion to the
2.Retract the drill chuck jaws fully by turning the body of the drill chuck counterclockwise.
3.Insert the arbor into the drill chuck. Tap the arbor lightly with a brass or other
Note: While it may not seem like there is anything keeping the drill chuck in place, the
Taper
Brass Tip
