Grizzly G0759 owner manual Table Travel, Longitudinal Feed, Cross Feed

Table Travel

The mill/drill table can be moved in the longitudi- nal (X-axis) and cross (Y-axis) directions.

Longitudinal Feed

The X-axis is moved by the handwheels shown in Figure 32 at the end of the table. These handwheels will move the table in both directions side-to-side. One complete revolution of either handwheel moves the longitudinal feed 0.100". There is also a scale on the front of the table for use when a tight tolerance is not required. The longitudinal feed can be locked in position by table locks located on the front of the table (see Figure 33).

Cross Feed

The Y-axis shown in Figure 32, is moved with the handwheel on the front of the table base. One complete revolution of the handwheel moves the cross slide 0.100". The cross feed can be locked into position by a table lock lever located on the right side of the cross slide underneath the table (see Figure 33).

X-Axis Handwheels

Y-Axis Handwheel

Figure 32. Table X- and Y-axis controls.

X-Axis Table Lock Levers

X-Axis Scale

Y-Axis Table Lock Levers

Figure 33. Table locks and scales.

-32- Model G0704 (Mfg. Since 08/11)