Grizzly G0759 owner manual Inventory, Contents Qty, Not Shown

Inventory

The following is a list of items shipped with your machine. Before beginning setup, lay these items out and inventory them.

If any non-proprietary parts are missing (e.g. a nut or a washer), we will gladly replace them; or for the sake of expediency, replacements can be obtained at your local hardware store.

Contents		Qty
A.	mill/Drill w/Stand	1
B.	open End Combo Wrench 17/19	1
C.	open End Combo Wrench 8/10	1
D.	bottle for Oil	1
E.	tool Box	1
F.	large Handwheel Handle	1
G.	Small Handwheel Handles	3
H.	t-Bolts M10-1.5 x 60 (vise mounting)	2
	Flat Washers 10mm (vise mounting)	2
	hex Nuts M10-1.5 (vise mounting)	2
I.	drill Chuck	1
J.	Chuck Key	1
K.	Phillips Screwdriver	1
L.	Flat Screwdriver	1
M.	arbor B16 x R8	1
N.	hex Wrench Set 2, 3, 4, 5, & 6mm	1 ea.
O.	Spindle Pin	1
Not Shown:
	hex Bolts M10-1.5 x 50	4
	Flat Washers 10mm	4

-14-

A

Figure 4. G0704 out of the crate.

NOTICE

If you cannot find an item on this list, care- fully check around/inside the machine and packaging materials. Often, these items get lost in packaging materials while unpack- ing or they are pre-installed at the factory.

D

B	E
	C

	M
K L		N	O
			F
J	I	H	G

Figure 5. Inventory.

Model G0704 (Mfg. Since 08/11)