Spindle Speed and

Direction

Setting the speed on the Model G0704 is a two part process. The gearbox in the headstock has two gear ranges and the motor is a variable speed unit. Together, these two systems provide an overall speed range of 50–2250 Rpm.

When the dial is turned up all the way, the motor draws the full amperage level. When combined with a cutting load, the motor can overheat and become damaged. If high speeds are needed, put the speed range into high "H" then turn the vari- able speed dial down, away from the maximum position. If the maximum Rpm is needed, reduce the cutting load as much as possible and mini- mize the operation time at these speeds.

To set the spindle speed:

1.Determine the appropriate spindle speed for your operation. See Calculating Spindle Speed on Page 26.

2.Select the appropriate speed range using the speed range selector knob (Figure 25). "H" represents the high speed range, which is capable of spindle speeds from 100–2250 RPM. "L" represents the low range, which is capable of spindle speeds from 50–1125 RPM.

Note: To maximize spindle torque, use the low range.

Speed Selection

Knob

Figure 25. Speed selector knob.

Model G0704 (Mfg. Since 08/11)

Note: It may be necessary to rotate the spindle by hand to get the gears to mesh properly.

3.Make sure the work area is clear and that all safety precautions are taken.

4.turn the variable spindle speed knob to the far left (slowest) position, then press the green start button and use the spindle direc- tion selection knob to choose the direction of spindle travel and start spindle rotation (Figure 26).

RPM Readout

 

 

Spindle Direction

Variable Spindle

 

 

Selection Knob

Speed Knob

 

 

 

 

 

 

 

Figure 26. Spindle direction selection knob.

5.Watch the RPM readout and adjust the vari- able spindle speed knob as needed until the desired RPM is reached.

NOTICE

AVOID OVERHEATING MOTOR!

DO NOT operate with variable speed dial at full RPM for than a couple minutes or motor overheating may occur. Instead, achieve the same spindle speed by using the high “H” speed range and reducing the motor RPM by turning the variable speed dial down.

-27-

Page 39
Image 39
Grizzly G0759 owner manual Spindle Speed Direction, To set the spindle speed