PCI-CTR05 User's Guide

Installing the PCI-CTR05

Optional components

If you ordered any of the following products with your board, they should be included with your shipment.

Cables

C37FF-xC37FFS-x

Signal termination and conditioning accessories

MCC provides signal termination and signal conditioning products for use with the PCI-CTR05. Refer to Field wiring, signal termination and conditioning for a complete list of compatible accessory products.

Unpacking the board

The PCI-CTR05 board is shipped in an antistatic container to prevent damage by an electrostatic discharge. To avoid such damage, perform the following procedure when unpacking and handling your board:

1.Before opening the antistatic container, ground yourself with a wrist-grounding strap or by holding onto a grounded object (such as the computer chassis).

2.Touch the antistatic container to the computer chassis before removing the board from the container.

3.Remove the board from the container. Never touch the exposed pins or circuit connections on the board.

If your board is damaged, notify Measurement Computing Corporation immediately by phone, fax, or e-mail. For international customers, contact your local distributor where you purchased the PCI-CTR05.

ƒPhone: 508-946-5100 and follow the instructions for reaching Tech Support.

ƒFax: 508-946-9500 to the attention of Tech Support

ƒEmail: techsupport@measurementcomputing.com

Installing the software

Install the software included with your board before you install the hardware. Installing the software first ensures that the information required for proper board detection is installed and available at boot up.

Refer to the Quick Start Guide for instructions on installing the software on the Measurement Computing Data Acquisition Software CD. This booklet is available in PDF at www.mccdaq.com/PDFmanuals/DAQ-Software-Quick-Start.pdf.

2-2

Page 11
Image 11
Measurement Specialties PCI-CTR05 manual Unpacking the board, Installing the software, Optional components, C37FF-xC37FFS-x