Installing the |
PC +5V | 20 | 1 | IRQ INPUT | |
DIN STROBE | 21 | 2 | IRQ ENABLE | |
DIN7 | 22 | 3 | DOUT7 | |
DIN6 | 23 | 4 | DOUT6 | |
DIN5 | 24 | 5 | DOUT5 | |
DIN4 | 25 | 6 | DOUT4 | |
DIN3 | 26 | 7 | DOUT3 | |
DIN2 | 27 | 8 | DOUT2 | |
DIN1 | 28 | 9 | DOUT1 | |
DIN0 | 29 | 10 | DOUT0 | |
OSC OUT | 30 | 11 | GND | |
CTR5OUT | 31 | 12 | CTR5GATE | |
CTR4OUT | 32 | 13 | CTR5CLK | |
CTR3OUT | 33 | 14 | CTR4GATE | |
CTR2OUT | 34 | 15 | CTR4CLK | |
CTR1OUT | 35 | 16 | CTR3GATE | |
CTR1CLK | 36 | 17 | CTR3CLK | |
18 | CTR2GATE | |||
CTR1GATE | 37 | |||
|
| 19 | CTR2CLK |
J1
Figure 2-1. Board connector J1
Information on signal connections
For general information regarding digital I/O techniques, including signal conditioning and low pass filters, refer to the Guide to Signal Connections. This document is available on our web site at www.mccdaq.com/signals/signals.pdf).
1 
20
The red stripe | 1 | |
identifies pin # 1 | ||
|
20
19
37
19
37
